Belt, Antriebsriemen, Zahnriemen
C7770-60014 Carriage Belt - Drives the carriage assembly - For use with 42-inch plotters

Cable Kit, Flachband-Kabel, Trailing-Kabel
C7770-60274 Carriage assembly trailing cable kit - Includes installation instructions, trailing cables, mounting clips, and a ferrite - Cables have 30-pin (M) edge connectors - 2.0m (6.5ft) long - For 42-inch models

C7769-60406 Cover kit for drive roller encoder sensor 

Encoder, Decoder
C7769-60254 Encoder disk assembly - Helps provide position the information of the paper

C7769-60375 Carriage (scan-axis) motor assembly - Includes cable
C7769-60377 Paper axis motor assembly - Includes cables 

C7769-60384 Drive roller encoder sensor

C4699-00016 Encoder spring

Strip, Encoder
C7769-60183 Encoder strip 24-inch
C7770-60013 Encoder strip 42-inch

C7769-60409 Bracket kit - Includes the left cutter guide bracket and left encoder holder

C7769-60169 Cutter bushing

Cutter, Messer
C7769-60390 Cutter assembly

C7770-60322 Cutter guide - Guide bar for the cutter assembly - For 42-inch plotters

Cable Kit, Kabel-Baum
C7770-60267 Ribbon cable kit - Includes installation instructions and ribbon cable with ferrite - Cable has 40 pin (F) connectors - 2.0m (6.5ft) long

Fan, Lüfter
C7769-60407 Vacuum fan assembly

Memory (DIMM) 
CH336-67011 256MB DIMM memory module - Upgrade DIMM for Designjet printers

PC Board, Mainboard, Haupelektronik
CH336-67001 Formatter (main logic) board - For the Designjet 510 printer series
CH336-67002 Electronics module - Contains main logic board, connectors for plug-in cards, connector for parallel interface cable, connector for USB cable, and cooling fan

Power Supply, Netzteil
CH336-67012 Power supply assembly - For the Designjet 510 printer series

CH336-67003 Right side cover assembly (Light Gray) - For the DesignJet 510 printer series
CH336-67004 Left side cover (Light Gray) - For the Designjet 510 printer series
CH337-67001 Top cover assembly (Light Gray) - With window - For the 42-inch DesignJet 510 series printer 

CH337-67002  Deflector kit - For the 42-inch DesignJet 510 printer series

Front Panel, Bedienfeld
CH336-67008 Front panel service kit - For the Designjet 510 printer series

C7770-60290 Tube guide - Black plastic guide that ink tube system sits in - For use with 42-inch plotters

Ink Supply Station, Pumpe, Patronen-Halterung
CH336-67010 Ink Supply Station (ISS) - Includes ink pump motor, pump sensor, and out-of-ink sensors - Installed in right side of printer

Ink Tubes Assembly, Schlauch-System, Schläuche
C7770-60286 Ink tubes assembly - Includes four ink tubes complete with hardware assemblies at both ends (carriage crane and ink supply station crane), and four setup pens - For use with the 42-inch Designjet 500/800 printer series

Printhead, Setup, Setup-Köpfe
C7769-60164 Setup printhead kit - Used to prime the ink tubes - Includes 4 setup printheads

Maintenance Kit, Wartungs-Kit
C7770-60287 Preventive Maintenance Kit - Includes idler pulley, spring tensioner, carriage base, service station, cutter assembly, setup pen assembly, belt, encoder strip and RIDs assembly - For use with the 42-inch Designjet 500/800 plotters

Gear Assembly
C7769-60408 Paper drive transmission gear kit - Includes two gears used to drive the paper drive roller

C7769-60289  Media deflector holders - For the Designjet 500/800 printer series

Platen, Walze
C7769-60174 Front platen kit - Includes platens for both the 24-inch and the 42-inch models
C7770-60303 Back platen assembly - Curved cover/guide that is installed below the paper drive roller - For use with 42-inch plotters

C7770-60289 Paper drive roller kit - Includes roller assembly, bushings, gear on roller, transmission gear kit, encoder disc, end thrust (Axial) spring, lint free cloth, rubber glove, and instruction sheets - For use with 42-inch plotters

Rollfeed Assembly
CH336-67009 Rollfeed assembly - For the DesignJet 510 series printer 

C7769-60379 Media sensor - Installed in the front of the rear platen

C7769-60391 Service station bracket - Installed on right-side of service station

Lifter, blauer Hebel
C7770-60015 Pincharm lift mechanism - Includes cam (a long bar) , cam bushings, pinch arm lever, pinch arm lever bushing

PC Board
C7769-60385 Interconnect PC board - Installed in right-side of printer

Pincharm, Stahlrollen
C7769-60175 Pincharm assembly with wheels

C7769-60378  Pincharm sensor - Installed in right front of print chassis 

Service Station, Reinigungs-Station
C7769-60374 Service station - Includes wipers, pen caps, and the right hand spittoon - Installed in right side of printer

Spittoon, Resttintenbehälter
C7769-60165 Left spittoon assembly - Contains absorbers which hold excess ink from printheads

Tensioner, Umlenkrolle
C7769-60176 Belt tensioner kit - Keeps carriage belt tight - Includes pulley and pulley mount bracket

HP DesignJet 510 CH337A Plotter Ersatzteile


Hier finden Sie uns, Lageplan
Drucker Service Arfert und Loose GbR
Bahrenfelder Chaussee 101
22761 Hamburg

Tel: 040 / 57 50 35
Fax: 040 / 57 70 64
Montag bis Freitag von 8.00 bis 18.00 Uhr

Drucker Service Arfert und Loose GbR, Bahrenfelder Chaussee 101, 22761 Hamburg
© Copyright 1999 Arfert und Loose GbR. Alle Rechte vorbehalten

Drucker Service Arfert und Loose GbR

Tel: 040 / 57 50 35

Fax: 040 / 57 70 64

Drucker und HP DesignJet Plotter Dienstleistungen

Brother, Canon, Epson, Fujitsu, HP, Kyocera, Lexmark, Minolta, NEC, Oki, Philips, QMS, Samsung, Seikosha, Siemens, usw.