Belt, Antriebsriemen, Zahnriemen
C7769-60182 Carriage belt - Drives the carriage assembly - For use with 24-inch plotters
Cable Kit, Flachbandkabel, Trailing-Kabel
C7769-60305 Carriage assembly trailing cable kit - Includes installation instructions, trailing cables, two mounting clips, and a ferrite - Cables are 1.4m (4.7ft) long with 30 pin (M) edge connectors - For use with 24-inch plotters
Cover
C7769-60406 Cover kit for drive roller encoder sensor
Encoder
C7769-60254 Encoder disk assembly - Helps provide position the information of the paper
Motor
C7769-60375 Carriage (scan-axis) motor assembly - Includes cable
C7769-60377 Paper axis motor assembly - Includes cables
Sensor
C7769-60384 Drive roller encoder sensor
Spring
C4699-00016 Encoder spring
Strip, Encoder
C7769-60183 Encoder strip 24-inch
C7770-60013 Encoder strip 42-inch
Bracket/Guide
C7769-60409 Bracket kit - Includes the left cutter guide bracket and left encoder holder
Cutter, Messer
C7769-60390 Cutter assembly
Guide
C7769-60179 Cutter guide - Guide bar for the cutter assembly - For 24-inch plotters
Cable Kit, Kabel-Baum
C7769-60298 Ribbon cable kit - Includes installation instructions and ribbon cable with ferrite - Cable has 40 pin (F) connectors - 1.6m (5.1ft) long
Fan
C7769-60407 Vacuum fan assembly
PC Board, Mainboard, Hauptelektronik
CH336-67001 Formatter (main logic) board - For the Designjet 510 printer series
CH336-67002 Electronics module - Contains main logic board, connectors for plug-in cards, connector for parallel interface cable, connector for USB cable, and cooling fan
Power Supply, Netzteil
CH336-67012 Power supply assembly - For the Designjet 510 printer series
Case Parts Cover
CH336-67003 Right side cover assembly (Light Gray) - For the DesignJet 510 printer series
CH336-67004 Left side cover (Light Gray) - For the Designjet 510 printer series
CH336-67005 Top cover assembly (Light Gray) - With window - For the 24-inch DesignJet 510 series printer
Deflector
CH336-67006 Deflector kit - For the 24-inch DesignJet 510 printer series
Front Panel, Bedienfeld
CH336-67008 Front panel service kit - For the Designjet 510 printer series
Ink Supply Station, Pumpe, Patronen-Halterung
CH336-67010 Ink Supply Station (ISS) - Includes ink pump motor, pump sensor, and out-of-ink sensors
Ink Tubes Assembly, Schlauch-System, Schläuche
C7769-60381 Ink tubes assembly - Includes 4 ink tubes complete with hardware assemblies at both ends (carriage crane and ink supply station crane), and 4 setup pens - For the 24-inch Designjet 500/800 printer series
Printhead, Setup, Setup-Köpfe
C7769-60164 Setup printhead kit - Used to prime the ink tubes - Includes 4 setup printheads
Maintenance Kit, Wartungs-Kit
C7769-60394 Maintenance Kit - Contains lubricant, gloves, cotton wipe, spring tensioner, foams, tubes, belt, encoder strip, setup pens, trailing cable, service station, cutter, and carriage - For use with the 24-inch DesignJet 500/800 plotters
Gear Assembly
C7769-60408 Paper drive transmission gear kit - Includes two gears used to drive the paper drive roller
Holder
C7769-60289 Media deflector holders - For the Designjet 500/800 printer series
Platen, Walze
C7769-60174 Front platen kit - Includes platens for both the 24-inch and the 42-inch models
C7769-60410 Back platen assembly - Curved cover/guide that is installed below the paper drive roller - For use with 24-inch plotters
Roller
C7769-60412 Paper drive roller kit - Includes roller assembly, bushings, gear on roller, transmission gear kit, encoder disc, end thrust (axial) spring, lint free cloth, rubber glove, and instruction sheets - For use with 24-inch plotters
Rollfeed Assembly
CH336-67009 Rollfeed assembly - For the DesignJet 510 series printer
Sensor
C7769-60379 Media sensor - Installed in the front of the rear platen
Bracket
C7769-60391 Service station bracket - Installed on right-side of service station
Lifter, blauer Hebel
C7769-60181 Pincharm lift mechanism - Includes cam (a long bar) , cam bushings, pincharm lever, pincharm lever bushing
Board
C7769-60385 Interconnect PC board - Installed in right-side of printer
Pincharm, Stahlrollen
C7769-60175 Pincharm assembly with wheels
Sensor
C7769-60378 Pincharm sensor - Installed in right front of print chassis
Service Station, Reinigungs-Station
C7769-60374 Service station - Includes wipers, pen caps, and the right hand spittoon
Spittoon, Resttintenbehälter
C7769-60165 Left spittoon assembly - Contains absorbers which hold excess ink from printheads
Tensioner , Umlenkrolle
C7769-60176 Belt tensioner kit - Keeps carriage belt tight - Includes pulley and pulley mount bracket
Foot, Ständer
C7769-60411 Foot kit - Contains four rubber feet for bottom of plotter - For the DesignJet 500/510/800 printer series, Part C7769-60411 is no longer supplied. Please order the replacement, CH336-67013
Hardware Kit
C7769-60405 Hardware kit - Includes various screws and nuts for the stand and touch screen assembly
HP DesignJet 510 CH336AR Plotter Ersatzteile